International Scientific Journals
of Scientific Technical Union of Mechanical Engineering "Industry 4.0"

This work is devoted to the study of the internal defect closure during metal broaching in step-wedge strikers with wedge and depression by FEM in Deform program. A through cylindrical hole with a diameter of 3 mm was considered as an internal defect. At the same time, three variants of the defect vertical location were modeled – in the workpiece center, near the upper face of the wedge and near the lower face of the depression. In all three cases, the internal defect closure is uneven. The most intense defect closure is observed when it is located in the workpiece axial zone. Defects located near the strikers surface zones are not closed well enough. The stress-strain state analysis showed that the defect location affects the distribution nature of stresses and strains along the workpiece section.

A computer simulation of the broaching of the workpiece in step-wedge-shaped strikers of the first and second configurations was carried out by the finite element method. The comparison was made according to the following parameters of the stress-strain state: equivalent strain, average hydrostatic pressure, damage criterion, as well as the deformation force. A comparative analysis of the stress – strain state showed that the second configuration of step-wedge-shaped strikers is the most optimal option for implementing the process of broaching rectangular or square blanks. When using them, a more uniform distribution of the stress state is realized, the deformation processing is sufficiently realized in comparison with the broaching in step-wedge-shaped strikers of the first configuration

This article describes the technology of the combined process “equal-channel angular pressing-drawing”. The analysis of the influence of this process on the structure and mechanical properties of aluminum, copper and steel wires is given. The results of the study showed that the proposed combined deformation method “equal-channel angular pressing-drawing” has a significant advantage over the existing technology for the production of high-strength wire. This deformation method due to the combination of two deformations: severe plastic deformation in a matrix with parallel channels and the process of deformation through a drawing die, allows to get a wire with an ultra-fine structure and a high level of mechanical properties, the required size and shape of the cross section in a small number of deformation cycles.