International Scientific Journals
of Scientific Technical Union of Mechanical Engineering "Industry 4.0"

The paper presents the results of studies of tribological properties of the contact of the tool steel composition Fe-18W-4Cr-1,2V with the magnesium alloy AZ91D strengthened by submicron powder filling out of SiC and severe plastic deformation (SPD), namely equalchannel angular pressing (ECAP). It is stated that introduction of SiC powder filling to the magnesium alloy the friction coefficient on the moving frictional contact increases, the wear rate reduces. These tribotecnical characteristics are influenced by the size and volume of the particles of powder filling, normal loading force and slip rate. SPD of the initial material results in reduction of the adhesion constituent of the friction coefficient.

In this paper, we present the results of the tribological studies of commercially pure copper (99.9% Cu) and a low-alloyed chromium bronze (Cu-0.5%Cr), contacting a graphite-containing material. The samples under study were produced with two types of microstructures: a coarse-grained (CG) one, having an average grain size of 100-130 μm after annealing, and a submicrocrystalline (SMC) one, having an average grain size of 0.30-0.50 μm after multi-cycle severe plastic deformation (SPD) processing via equal-channel anglar pressing (ECAP) combined with Conform. It is shown that for the samples produced by ECAP-Conform, having an SMC structure, the friction coefficients are 12 – 20% lower than for the as-annealed samples, having a CG structure.