TRANSPORT TECHNICS. INVESTIGATION OF ELEMENTS. RELIABILITY

Operation guidelines for proper arrangement of pumps in the marine steam propulsion system

  • 1 Faculty of Engineering, University of Rijeka, Rijeka, Croatia
  • 2 Maritime Department, University of Dubrovnik, Dubrovnik, Croatia
  • 3 Faculty of Informatics, Juraj Dobrila University of Pula, Croatia

Abstract

: In this paper are investigated and presented the most influential operating parameters and the guidelines for proper arrangement of pumps in the condensing/feedwater heating system. The observed system operates in marine steam propulsion power plant. In the analyzed system operates three pumps: Condensate Pump (CP), Auxiliary Pump (AP) and FeedWater Pump (FWP). Considering all observed pumps, FWP is the dominant mechanical power consumer because it operates with the highest pressure difference and with the highest fluid mass flow rate. Used mechanical power and losses (energy and exergy) of all observed pumps are directly proportional to fluid mass flow rate through the pump – higher fluid mass flow rate through the pump will result with higher mechanical power used by pump and with higher losses (both energy and exergy) and vice versa. Energy and exergy efficiencies of the observed pumps have reverse proportional trends. The most influencing factor related to the pump efficiency (both energy and exergy) is the pump inlet pressure. Pump inlet pressure is directly proportional to the pump exergy efficiency, but simultaneously pump inlet pressure is reverse proportional to pump energy efficiency.

Keywords

References

  1. Sutton, I. (2017). Plant design and operations. Gulf Professional Publishing
  2. Elhelw, M., Al Dahma, K. S., & el Hamid Attia, A. (2019). Utilizing exergy analysis in studying the performance of steam power plant at two different operation mode. Applied Thermal Engineering, 150, 285-293. (doi:10.1016/j.applthermaleng.2019.01.003)
  3. Kopac, M., & Hilalci, A. (2007). Effect of ambient temperature on the efficiency of the regenerative and reheat Çatalağzı power plant in Turkey. Applied Thermal Engineering, 27(8-9), 1377-1385.
  4. (doi:10.1016/j.applthermaleng.2006.10.029)
  5. Adibhatla, S., & Kaushik, S. C. (2014). Energy and exergy analysis of a super critical thermal power plant at various load conditions under constant and pure sliding pressure operation. Applied thermal engineering, 73(1), 51-65.
  6. (doi:10.1016/j.applthermaleng.2014.07.030)
  7. Ahmadi, G. R., & Toghraie, D. (2016). Energy and exergy analysis of Montazeri steam power plant in Iran. Renewable and Sustainable Energy Reviews, 56, 454-463.
  8. (doi:10.1016/j.rser.2015.11.074)
  9. Noroozian, A., Mohammadi, A., Bidi, M., & Ahmadi, M. H. (2017). Energy, exergy and economic analyses of a novel system to recover waste heat and water in steam power plants. Energy conversion and management, 144, 351-360.
  10. (doi:10.1016/j.enconman.2017.04.067)
  11. Mitrović, D., Zivkovic, D., & Laković, M. S. (2010). Energy and exergy analysis of a 348.5 MW steam power plant. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 32(11), 1016-1027. (doi:10.1080/15567030903097012)
  12. Mrzljak, V., Lorencin, I., Anđelić, N., & Car, Z. (2021). Thermodynamic Analysis of a Condensate Heating System from a Marine Steam Propulsion Plant with Steam Reheating. Journal of Marine Science and Application, 20(1), 117-127.
  13. (doi:10.1007/s11804-021-00191-5)
  14. Naserabad, S. N., Mehrpanahi, A., & Ahmadi, G. (2019). Multi-objective optimization of feed-water heater arrangement options in a steam power plant repowering. Journal of Cleaner Production, 220, 253-270. (doi:10.1016/j.jclepro.2019.02.125)
  15. Mrzljak, V., Poljak, I., & Žarković, B. (2018). Exergy analysis of steam pressure reduction valve in marine propulsion plant on conventional LNG carrier. NAŠE MORE: znanstveni časopis za more i pomorstvo, 65(1), 24-31. (doi:10.17818/NM/2018/1.4)
  16. Mrzljak, V., Žarković, B., & Poljak, I. (2017). Energy and exergy analysis of sea water pump for the main condenser cooling in the LNG carrier steam propulsion system. Mathematical Modeling, 1(3), 144-147.
  17. Kanoğlu, M., Çengel, Y. A., & Dinçer, İ. (2012). Efficiency evaluation of energy systems. Springer Science & Business Media.
  18. Dincer, I., & Rosen, M. A. (2012). Exergy: energy, environment and sustainable development. Newnes.
  19. Poljak, I., Orović, J., Mrzljak, V., & Bernečić, D. (2020). Energy and exergy evaluation of a two-stage axial vapour compressor on the LNG carrier. Entropy, 22(1), 115. (doi:10.3390/e22010115)
  20. Mrzljak, V., Prpić-Oršić, J., & Poljak, I. (2018). Energy power losses and efficiency of low power steam turbine for the main feed water pump drive in the marine steam propulsion system. Pomorski zbornik, 54(1), 37-51. (doi:10.18048/2018.54.03)
  21. Aljundi, I. H. (2009). Energy and exergy analysis of a steam power plant in Jordan. Applied thermal engineering, 29(2-3), 324-328. (doi:10.1016/j.applthermaleng.2008.02.029)
  22. Mrzljak, V., Poljak, I., & Mrakovčić, T. (2017). Energy and exergy analysis of the turbo-generators and steam turbine for the main feed water pump drive on LNG carrier. Energy conversion and management, 140, 307-323. (doi:10.1016/j.enconman.2017.03.007)
  23. Erdem, H. H., Akkaya, A. V., Cetin, B., Dagdas, A., Sevilgen, S. H., Sahin, B., ... & Atas, S. (2009). Comparative energetic and exergetic performance analyses for coal-fired thermal power plants in Turkey. International Journal of Thermal Sciences, 48(11), 2179-2186. (doi:10.1016/j.ijthermalsci.2009.03.007)
  24. Mrzljak, V., Poljak, I., & Medica-Viola, V. (2017). Dual fuel consumption and efficiency of marine steam generators for the propulsion of LNG carrier. Applied Thermal Engineering, 119, 331-346. (doi:10.1016/j.applthermaleng.2017.03.078)
  25. Jahangiri, A., & Ameri, M. (2020). Interaction effects of natural draft dry cooling tower (NDDCT) performance and 4E (energy, exergy, economic and environmental) analysis of steam power plant under different climatic conditions. Sustainable Energy Technologies and Assessments, 37, 100599. (doi:10.1016/j.seta.2019.100599)
  26. Koroglu, T., & Sogut, O. S. (2018). Conventional and advanced exergy analyses of a marine steam power plant. Energy, 163, 392-403. (doi:10.1016/j.energy.2018.08.119)
  27. Lemmon, E. W., Huber, M. L., & McLinden, M. O. (2010). NIST Standard Reference Database 23, Reference Fluid Thermodynamic and Transport Properties (REFPROP), version 9.0, National Institute of Standards and Technology. R1234yf. fld file dated December, 22, 2010.
  28. Khanmohammadi, S., Azimian, A. R., & Khanmohammadi, S. (2013). Exergy and exergo–economic evaluation of Isfahan steam power plant. International Journal of Exergy, 12(2), 249-272. (doi:10.1504/IJEX.2013.053386)
  29. Ameri, M., Ahmadi, P., & Hamidi, A. (2009). Energy, exergy and exergoeconomic analysis of a steam power plant: A case study. International Journal of energy research, 33(5), 499-512. (doi:10.1002/er.1495)
  30. Poljak, I., Orović, J., & Mrzljak, V. (2018). Energy and exergy analysis of the condensate pump during internal leakage from the marine steam propulsion system. Pomorstvo, 32(2), 268-280.
  31. (doi:10.31217/p.31.2.12)
  32. Ameri, M., Mokhtari, H., & Bahrami, M. (2016). Energy, exergy, exergoeconomic and environmental (4E) optimization of a large steam power plant: a case study. Iranian Journal of Science and Technology, Transactions of Mechanical Engineering, 40(1), 11-20. (doi:10.1007/s40997-016-0002-z)
  33. Baressi Šegota, S., Lorencin, I., Anđelić, N., Mrzljak, V., & Car, Z. (2020). Improvement of marine steam turbine conventional exergy analysis by neural network application. Journal of Marine Science and Engineering, 8(11), 884. (doi:10.3390/jmse8110884)
  34. Lorencin, I., Anđelić, N., Mrzljak, V., & Car, Z. (2019). Genetic algorithm approach to design of multi-layer perceptron for combined cycle power plant electrical power output estimation. Energies, 12(22), 4352. (doi:10.3390/en12224352)
  35. Ebrahimgol, H., Aghaie, M., Zolfaghari, A., & Naserbegi, A. (2020). A novel approach in exergy optimization of a WWER1000 nuclear power plant using whale optimization algorithm. Annals of Nuclear Energy, 145, 107540. (doi:10.1016/j.anucene.2020.107540)
  36. Anđelić, N., Baressi Šegota, S., Lorencin, I., Poljak, I., Mrzljak, V., & Car, Z. (2021). Use of Genetic Programming for the Estimation of CODLAG Propulsion System Parameters. Journal of Marine Science and Engineering, 9(6), 612. (doi:10.3390/jmse9060612)

Article full text

Download PDF