• MATERIALS

    Environmentally friendly nanoscale modifiers for polymer matrices

    Machines. Technologies. Materials., Vol. 18 (2024), Issue 3, pg(s) 109-110

    The article presents the results of studies of the structure and properties of nanodispersed silicon carbide particles using the method of infrared spectroscopy of disturbed total internal reflection, as well as electret thermal analysis. Temperature ranges of the occurrence of TST in the polymer matrix have been established, which may be due to the processes of melting and oxidation of the polymer matrix, accompanied by the release of charge carriers. The activity of silicate-containing particles used to modify polymer matrices has been analyzed. It has been shown that the introduction of SiC particles into the polymer increases the intensity of TST peaks. The prospects of using ultrafine SiC particles obtained from natural raw materials for the modification of polymer materials are considered.

  • MATERIALS

    EFFECTS OF MECHANOCHEMICAL TREATMENT OF ThO2 WITH UO3 AND CеO2

    Machines. Technologies. Materials., Vol. 12 (2018), Issue 1, pg(s) 37-40

    The paper presents the effects of the mechanochemical activation of ThO2-UO3 and ThO2-CeO2 mixtures in air and (for ThO2-UO3) in suspension in H2O or CHCl3. Planetary ball mill (Pulverisette 5, Fritch) with stainless steel triboreactors and milling balls from the same materials are used. Milling for 5 h of the ThO2-UO3 mixture does not affect significantly the crystal structure of the ThO2 but leads to amorphization of UO3, sharp decrease of its crystallites size and increase of the ionic character of the U-O bond. Storage of the activated product (2 months at room temperature) or heating (3 h, 165 oC) leads to partial relaxation of the UO3 crystal structure. The X-ray diffraction data does not give proves for formation of ThO2-UO3 solid solution.

    Formation of solid solution Ce0.6Th0.4O2 accompanied with some amount of amorphisized ThO2, is established as a result of co-milling at the same conditions of the mixture ThO2 – CeO2 with a mole ratio 1. XRD-determined lattice parameter (5.4804(9) Å) and crystallites size (14 nm) of the obtained solid solution are in satisfactory agreement with literature data for the same product obtained via wet chemistry route.

  • MECHANOCHEMICALLY INDUCED PHASE TRANSFORMATION AND LEACHING OF DECAY PRODUCTS FROM U(IV, VI) OXIDE

    Materials Science. Non-Equilibrium Phase Transformations., Vol. 2 (2016), Issue 4, pg(s) 6-9

    Depleted U3O8 was mechanically activated in suspension with tributyl phosphate (TBP), trioctylamine (TOA) and ethylenglycolmonomethylether (EGME) in planetary ball mill with stainless steel vessels and balls. X-ray diffractograms and IR spectra of the activated solid samples were taken. The radioactivities of 238U and 234Th in the leaching solutions were determined by α/β liquid scintillation spectrometry. The reduction degree of the oxide, the mean crystallite size of U3O8 and U3O7 and the leaching of 238U and 234Th as a result of the mechanoactivation were determined. Higher degree of 238U and 234Th leaching was achieved when mechanoactivation with TBP was performed. No leaching of 238U daughter product (234Th) proceeded at mechanoactivation with TOA and EGME. The role of the solvents complexation ability, milling induced increase of crystal defect concentration and UO2 – ThO2 solid solution formation is discussed. Further studies have to be made to elucidate the potential of the applied approach as a step in spent nuclear fuel processing.