International Scientific Journals
of Scientific Technical Union of Mechanical Engineering "Industry 4.0"

The influence of non-metallic inclusions on the formation of defects in deformed steels and their role in providing crack resistance are considered. It is shown that non-metallic inclusions as stress and strain concentrators are one of the most dangerous sources of defect initiation in steels during pressure treatment. It has been established that the nature of cracks and the features of their growth near nonmetallic inclusions are determined by the type of inclusions, as well as by the scheme of the local stress state, which depends on the loading conditions. An analysis was made of the features of the initiation and development of the cracks near non-metallic inclusions of various types during tensile strain, compressive and bending deformation. It is shown that the most severe way of deformation for the inclusion-matrix system is tensile strain, the softest is compression.

One of the main problems in the plastic deformation of materials is the determination of the coefficient of friction as well as the subsequent application of the simulation for comparative analysis. However forecasting process and matching between simulation and experimental data is still a problem. Causes of this are factors such as roughness, mechanical properties of the material, chemical composition, etc. which strongly influence the behavior of the material in the simulation of the process.

In this study, an approach is proposed to determine the changeable coefficient of friction in the deformation process experimentally, taking into account implicitly the influence of surface roughness on the friction curves. For the comparative analysis between experiment and simulation of the process, the experimental data for objective assessment was introduced. Nevertheless, there are differences between experiment and simulation, which is most evident in high loads, using lubricants differing from more than 12 units for graphite lubricant, with more than 6 units with oil and with dry friction with 8 units.