International Scientific Journals
of Scientific Technical Union of Mechanical Engineering "Industry 4.0"

The paper examines the dynamic analysis of a hydraulic lift that is used for lifting and lowering vehicles. These lifts are implemented in various servicing facilities for the repair of vehicles. The lifts consist of various mechanical and hydraulic parts and besides lifting and lowering the vehicle, they need to keep the vehicle lifted for a certain amount of time. During the work operations, the lift’s main parts are heavily loaded. The method of analysis consists of 3D modeling of the Hydraulic lift and carrying simulations with software. This enables to analyze the dynamics of motion, identify the forces and stresses in lift parts and the form and intensity of oscillations that can cause failures of parts and concerns about the safety. Conclusions from this paper will be useful regarding the loading dynamics on the Hydraulic Lift during lifting and lowering, and design considerations. Results will be shown in graphical form, in time dependence. The Hydraulic Lift is modeled based on the Data from the standard manufacturer. The software that will be used for modelling and analysis is SimWise 4D.

Modern vehicle braking systems mainly are based on deceleration of vehicle and tire slip control. Trends in improving vehicle braking performance give rise to a large variety of braking systems and control strategies. An anti -lock braking system is an electronic braking process control system, which greatly increases the ability of the driver and vehicle to avoid road accidents even during difficult braking conditions or circumstances. The load (number of passengers in the vehicle) which is transmitted to the road surface through the vehicle tires is an issue which directly affects the braking efficiency of the vehicle during stopping. The braking efficiency also depends on
the material of the road surface, climatic condition, road condition, vehicle speeds and tire condition.
The purpose of this paper is investigation the impact of the number of passengers in the vehicle during the braking process, respectively to determine the performance of the braking of vehicles equipped with modern mechatronic braking systems such as: Antilock Braking System, Electronic Braking System, Emergency Brake System and Electronic Brake-force Distribution System.
The braking performance of the vehicle was determined experimentally through the XL Meter device which was fixed on the windshield of the VW Polo vehicle. The tests were performed on asphalt roads for different speeds of 40, 60 and 80 km/h. The determination of the center of gravity of the vehicle and the reaction forces in the front and rear axles was performed through the devices in the Motor Vehicle Laboratory of the Faculty of Mechanical Engineering and the developed mathematical model for calculating static and dynamic reactions forces for the respective axes. The obtained results will help the traffic experts in the analysis of road accidents.

In the Republic of Kosovo, the unemployment rate has an increasing trend, the average monthly income is still low, which makes it impossible to buy a new vehicle, so they are forced to buy vehicles imported from European countries, which have a h igh rate of amortization.
Citizens who own used vehicles are obliged to perform services that cost less by avoiding quality equipment and replacing them with non-know manufactures for spare parts which cost cheaper compared to manufacturers of well-known and guaranteed brands. The use of such spare parts is directly affecting the increase in the number of accidents in the territory of the Republic of Kosovo. In this paper is study the efficiency of brake pads from different manufacturers – brands in the term of the braking system in passenger vehicles such as: braking time, maximum deceleration and braking distance. The tests were done with used vehicles equipped with the ABS system, on roads with dry asphalt. The used tires are from radial construction with summer characteristics. Depending on the treated methodology, the adequate equipment such as Xl meter, video cameras and meter are used. The obtained results through the decelerometer device (Xl meter) for deceleration of the vehicle and other indicators of the efficiency of the braking system has done with the case of emergency braking. Prior to each test, the predicted used vehicle has performed also technical inspection of the vehicle braking system in the Licensed Centers for technical inspection of the vehicle.